What does resetting the Kam Do?

Most of these are settings for fuel trims and information to help with idle stability. You would want to reset the KAM after fixing a mechanical issue like an air leak or a bad tank of gas. This functions like reloading the tune file but you do not have to go through the whole process.

How do you reset a Kam Focus ST?

Connect the APV3 to your OBD II port. Scroll down to “Trobleshooting” on the AP. From that screen, scroll down to “Reset KAM” then press the enter button.

What is keep alive memory?

Keep alive memory (KAM) is a type of volatile RAM memory that can be wired straight to the battery so that its data won’t be erased when you turn off the ignition. KAM is crucial because it stores data regarding drive cycles. This memory constantly changes based on driving and sensor inputs.

What is a Kam fuse?

Only show this user. Fuse 26 in the fuse box under the bonnet. It stands for Keep Alive Memory (I think). It basically “remembers things” to help smooth running. Therefore if you have a problem, and remove it, it “forgets” the problem (and normally cures it).

What is reset keep alive memory?

Description. Resetting the KAM returns the PCM memory to its default setting. Adaptive learning contents such as idle speed, refueling event, and fuel trim are included.

How do you reset the PCM on a 2014 Ford Focus?

How to Reset the Ford PCM

1. Open the hood of the Ford. Loosen the lock nut located on the negative battery cable connector with a socket and ratchet.
2. Wait for 20 minutes while the PCM bleeds off the electricity it stores for backup power. Once the power drains from the PCM, it resets.

What are Kam codes?

This memory storage component is called the “Keep Alive Memory” (KAM) system. Anytime you see a P0603 error, it means the engine control module is not effectively using the stored information and is instead operating on default parameters.

Does disconnecting the battery reset the PCM?

A. It depends on the car’s age and type of ECU used. On some older cars, disconnecting the battery will reset the system but in most new cars it does nothing, except potentially reset the clock and radio station presets.

How do I fix Kam error?

How to Fix P0603

1. Fully charge your battery so all measurements you take are accurate.
2. Inspect the battery cables for corrosion, damage or loose connections.
3. Make sure the wires going into the fuse box wiring harness are undamaged.
4. Located and inspect the engine control module and all wiring going to and from it.

Can you flash a PCM yourself?

Doing your own flash reprogramming is not without risk. Any number of things can go wrong during the installation process which may result in an incomplete update or a frozen PCM.

What is a Kam error?

What is a Kam reset and how does it work?

KAM reset is what makes the difference what is this learning process thing and how to do it? The ECU “learns” about your engine as you drive the car. The “learning” is actually a process that the ECU uses to track the tolerance changes of the sensors and actuators on the engine.

What happens when you reset the Kam in AutoCAD?

A reset will start the learning processes over by rebooting the code for each module. This does not clear the learned values in the KAM. By resetting the KAM the stored values would then be cleared back to their defaults. Which is best to do after you add a tune to your car?

How do I Reset my PCM when replacing defective parts?

You’ll also want to reset your truck’s PCM when you replace defective parts. Figure 1. Disconnect the negative cable of the battery. Open your hood and remove the negative cable from your truck’s battery. Figure 2. Turn on truck’s headlight. Turn on your truck’s headlights to fully drain any reserved power.