How do I reset my Panasonic top load washer?

If you see no change, you can try a Master Reset. This will reset all of the onboard componentry and is often successfully used by appliance technicians. Open and close the door of the washing machine 6 times within 12 seconds. Then, run the rinse/spin cycle without clothing to see if your problems are resolved.

How can I fix U12 error in my Panasonic washing machine?

Make sure there are no clothes stopping the door from closing. Check that the machine is not over loaded. Check that the washing machine has been levelled as per FAQ for levelling top loader washing machines. Check for any obstructions.

What is U error in Panasonic washing machine?

Possible drain hose/filter blockage or drain pump failure. U12 – Unclosed lid. U13 – Spin or Air Dry is not possible (washer dryers only). U14 – Water supply error.

What is error u11 in Panasonic washing machine?

It is clogged. Its tip is immersed in water.

What is U14 error in Panasonic washing machine?

Troubleshooting – U14 (unable to supply water) is displayed on my Washing machine? If U14 is displayed, There is not enough water being poured into the washing machine. After correcting the problem, open the door, close it & then start the wash again.

How do you get water out of a top loading washing machine?

How to Manually Drain a Top-Loading Washing Machine

1. Step 1: Turn off the power and lay down towels.
2. Step 2: Locate the drain hose at the back of the washing machine.
3. Step 3: Drain the water.
4. Step 1: Turn off the power and lay down towels.
5. Step 2: Locate the drain hose.
6. Step 3: Drain the water.
7. Step 4: Scrub the filter.

What is U11 error?

If U11 is displayed, check & confirm the following? Check the drain hose for any of the following problems: It is clogged. Its tip is immersed in water. It extends further than 3 metres.

How do I fix e10 error on my Panasonic washing machine?

Resolution:

1. Check the water supply.
2. Clean the filter in the inlet hose next to the tap.
3. Ensure correct position of the drain hose.
4. Ensure correct drain height.
5. Clean the pump and filter.
6. Check for blocked drain.
7. Check the drainage hose for possible kink or twist.
8. Use less soap powder.

What does U13 mean on a Panasonic washing machine?

unable to spin-dry
Troubleshooting – U13 (unable to spin-dry) is displayed on my Washing machine?

Why is there standing water in my washing machine?

Your washer may have a clogged drain hose or the pump may be broken. A broken lid switch or belt could also be the culprit. It may even be something as simple as the hose being jammed. Whatever the reason, the water will need to be drained from the washing machine before any work or diagnosis can be done.