What plastic is best for gears?

What plastic is best for gears?

Plastic materials for gears Most plastic gears are made from nylon and acetal. But nylon absorbs moisture with resultant changes in properties and dimensions. Acetal copolymers provide long-term dimensional stability as well as high fatigue and chemical resistance over a wide temperature range.

What are POM gears?

Generally, POM, PA, and PC are used as materials for injection molded plastic gears, among which POM is most abundantly used [1]. For POM gear, their use for high tooth root stress is limited to ca. 40 MPa at 80 °C and working temperature of POM is limited due to its low melting temperature (ca. 160 °C).

How much torque can a plastic gear take?

Plastic gears can be used successfully without lubrication in 60 to 70% of open gear applications….Assignment: metal gear replacement.

Center distance: 5 in.
Input speed: 1,200 rpm
Start-up torque: 1,200 in.-lb
Continuous torque: 700 in.-lb

Should I grease plastic gears?

Wherever possible, you should lubricate plastic components to reduce friction and wear, and increase component life. Tests show that lubricated plastic sliding bearings last up to five times longer than nonlubricated ones.

Is acrylic good for gears?

Acrylic is a sturdy and useful plastic, commonly used in robotics applications due to its functionality, availability, and looks. At the right speed, acrylic and other soft plastics can be smoothly milled to yield very beautiful results.

Is Delrin good for gears?

The most widely used DuPont resin for gears, Delrin® provides strength and stiffness without the need for glass fiber reinforcement.

Do plastic gears wear out?

Limitations of plastic gears And because plastic isn’t as durable as metal, plastic gears can have their teeth worn down from repeated use – although this can be offset by adding a coating to the teeth. Other limitations include: Lower load-carrying capacity.

How do you identify plastic gears?

Expect the differences between plastics and metals to manifest themselves in the tooth profiles too. Plastic gears tend to have taller tooth profiles in part to make room for changes in center-to-center distance variations.

Can I use wd40 on plastic?

WD-40 can be used on just about everything. It is safe for metal, rubber, wood and plastic. WD-40 can be applied to painted metal surfaces without harming the paint. Polycarbonate and clear polystyrene plastic are among the few surfaces on which to avoid using a petroleum-based product like WD-40.

Can I use lithium grease on plastic gears?

The answer is: yes, it is by far the best lubricant for nylon gears. No, it will not do anything bad to your gears. White lithium grease works perfectly with nylon gears. People have been using it for lubricating RC servo gears for forever.

Is polycarbonate good for gears?

Polycarbonate, for instance, is not a good gear material because of its poor chemical resistance, lubricity, and fatigue properties.