Who makes Hydro Flame furnace?

Who makes Hydro Flame furnace?

Technical Details

Manufacturer ‎Atwood
Brand ‎Atwood
Model ‎32690
Item Weight ‎29 pounds
Product Dimensions ‎20 x 16.5 x 7 inches

How do you turn on the Hydro Flame on a furnace?

How to Light an Atwood Hydro-Flame Furnace

  1. Charge your RV’s battery up and turn the Atwood Hydro-Flame furnace’s gas valve on to the “pilot” position.
  2. Light a match while pushing and holding the gas valve.
  3. Allow the gas flame to burn for a moment before switching the gas valve over to the “on” position.

Is Atwood and Dometic the same?

Atwood is now Dometic They expanded the business by developing the “universal rubber door bumper” which put an end to door rattles in early automobiles.

How do I turn off my Hydro Flame furnace?

You can pull the fuse for the fan and shut the gas off. There is a circuit breaker/switch on inside accessed by removing outside cover. Turn it off……that will cut power to blower and gas valve.

What does a sail switch do?

Sail switches find application in the detection of fluid flow and measurement of fan speeds. A sail switch might be used to protect a fan forced pellet stove, central heating system, electric heating element from being energized before the air flow from the blower is established.

Did Atwood go out of business?

Atwood is now Dometic The Atwood brothers continued their success in the burgeoning auto business by manufacturing door hinges and seat adjusters. As travel trailers became popular, Atwood entered the RV market with a trailer coupler in 1936, the screw-type trailer jack in 1949, and surge brakes in 1960.

What is ignition lockout fault?

What does ignition lockout fault mean? When a sensor detects an unsafe condition, the furnace controller will shut off the power and fuel to prevent hazards. This is known as an ignition lockout, a condition that can be caused by a number of different sensors found in your furnace.

Why is my Atwood Hot water heater not working?

One of the most common problems with Atwood RV water heater is a pilot outage. This can happen if you have a weak gas control magnet or if the thermocouple needs to be replaced. For poor pilot flame, you would need to replace the orifice. If it is not too old hen you can try cleaning the orifice and see how it goes.